Symantec endpoint protection is not updating

Therefore, the Symantec Endpoint Protection ELAM component is not enabled, and does not enable after you upgrade to Windows 10 with Symantec Endpoint Protection installed.

You either need to install a version of SEP that specifically supports Version 1607 or uninstall it and update your system, then install it again after the fact.The operating system upgrade stops if it detects an earlier version of Symantec Endpoint Protection.The following operating system upgrade paths are supported with 12.1.6 MP1 or 12.1.6 MP1a installed: Windows 7 does not include Early Launch Antimalware (ELAM).The incompatability is likely a soft incompatability, in that, Microsoft has determined it can or has cause a problem for users.This check is done for your own good, so you don't have to contact us with a bigger problem, like your system is stuck in a boot loop because of SEP.

Leave a Reply